Caring for LaserJet Printers

Here are some tips for your printers print durable and satisfactory results, especially for species such as the Laser printers: LaserJet 4L, 5L, 6L, 1000, 1010, 1020, 2100, 2200, 4000, 5000 etc..
1. Do not drop pieces "wire strapless" (foreign objects) in the paper tray, or holes in the printer, this caused  heating technology using a plastic film printer (fuser film sleeves), so easily torn by sharp objects, and the resulting paper crumpled and prints some spots. 

2. Do not try to force pulled out a paper that 'HOUR' forcibly, try pulling the same direction as the printer prints, if it does not get much better than bring it to the nearest service center, rather than forced and must replace the parts (usually a movie, and gear) are easy to fall off when the paper is pulled with force. 

3. Voltage / Electricity: Many printer that hangs / corrupted just because there is no stable electricity protection, try using a stabilizer / ups with servo-motor system, and grounding does not exceed 5volt. (Parts DC Controller in the printer, are sensitive to electrical spikes) 

4. Do not turn on the printer for too long (overnight) without being used, let alone the power off without a stabilizer. 

5. Damaged or not damaged, make a point every six months once the printer is then brought to the nearest service, in order to clean the inside of the toner powder grains. 

6. Do not force the toner that has been leaking for printing, will cause the pile of grain toner on the heater, resulting in the attachment of the toner in the heater and the pressure roller printer -> print result of permanent disability (not good).