Monday, October 17, 2011

How to fix computer part III - BIOS Problem
















BIOS ProblemsSymptoms:Be careful in Bios Update, as he got the wrong update your BIOS version, the PC so no way you can not even get into the BIOS. 
Solution:Usually Update can not be undone, only certain type of motherboard that has a backup BIOS chip it, there is saved the original BIOS types that can not be removed, to be able to restore your stay special Jumper Position move that usually have no instructions in the manuals. Then hidupka PC and wait 10 seconds, the original BIOS on Restore, restore Jumper position on the starting position, and the PC is ready to run again. If the motherboard does not have pasilitas, the BIOS chip should be sent to the manufacturer, type your BIOS can see in the manuals. Be careful not to install the BIOS IC legs broken or inverted position. 
Symptoms:CPU Beep sound in the speaker a few times and there is no display to the screen, when the monitor is not problematic. 
Solution:Beep Beep indicates a specific error message from the BIOS, it shows the type error Beep what happens on the PC, usually an error on non-detectable Memory, VGA Card, which is not installed properly, even Processor Monitor data cable could be the cause. Please check the problem.
The following BIOS error message:Sound errors are usually not all motherboard BIOS the same error signal depending on the type of BIOS.[AMI BIOS] 
Beep 1x: RAM / Memory not installed or Damaged Good, Beep 6x: Gate A20 Error - Indicates damaged or IC Keyboard Gate A20 of his own, 8x Beep: Grapihic Card / VGA Card is not installed properly or Damaged, Beep 11x: Checksum Error, check Bios Batre, and replace with new.[AWARD BIOS] 
1x Long Beep: RAM / Memory not installed or Damaged Good, Beep 1x 2x Short Length: Damage At Graphic Card (VGA), can also check on the installation of slot does not fit (not entered), Beep 1x 3x Short Length: Keyboard failure or not installed. No beep interrupted / continuous sound: RAM or Graphic Card not detected. 
CMOS Batrey Damaged / WeakSymptoms: CMOS Checksum Message Appears Vailure / Batrey Low, due to tegangna which supply IC CMOS / BIOS is not normal because batrey weak, so that the BIOS settings back to factory default Default-nya/setingan, and hardware configuration should be in Reset. 
Solution: Replace Soon his Batrey 
Symptoms: The CPU is often Hang? 
Solution: There are several factors including the hanging occurred: There BadSector on the hard drive, Viruses There, There is a problem in hardware such as Memory Dirty / Damaged, Mboard Dirty / Damaged, Fan Cooling fan rotation was already weak, unstable power supply ... .. should not be forced to use because it will result in more fatal, please contact: us to be able to resolve the issue 
Symptoms: The computer is often what causes the blue screen appears? 
Solution: The message could be caused Blue Screen windows system is broken, Can of Memory, Can from 
the hard drive, can be from other components, depending on the blue screen message is displayed. 
Symptoms: The computer is so much slower than before, though initially not so slow 
Solution: The cause of the process is slow your computer there are several factors: Space hard disk is too full, too many programs / software that is consuming disk space and memory, there is a virus, hard drive badsector.

Digg Google Bookmarks reddit Mixx StumbleUpon Technorati Yahoo! Buzz DesignFloat Delicious BlinkList Furl

0 comments: on "How to fix computer part III - BIOS Problem"

Post a Comment